Solids Control Equipment

SB6×8 F J C P-13(75kW) SB—means: SB series single-stage single-suction sand pump 6—Indicating: pump outlet diameter (in) 8—Indicating: pump inlet diameter (in) F-means: Reverse (looking at the pump inlet, the pump rotates counterclockwise, and the pump ou...

Hello, everyone, today we’d like to introduce our HHQ series shearing and mixing device, which is used in oil drilling, subway shield construction, tunnels and trenchless horizontal directional drilling construction. They are mainly used to shear high mol...

This mud mixer is mainly composed of a shearing pump, a jet mixing hopper and manifold valves, and is equipped with a magnetic starter. The electric motors are all explosion-proof, explosion-proof grade is BT4, and the protection grade is IP55, stable per...

What should be paid attention to in the inspection and debugging of the ignition system of the ignition device of the discharge pipeline? 1). Check and tighten the igniter high-voltage cable plug and the ignition rod joint by hand (without tools), and sho...

What are the installation steps of the horizontal ignition device ? 1). According to the connection form of the discharge pipeline, connect the combustion cylinder and the discharge pipeline with the corresponding connector, and fix the combustion cylinde...

How to deal with the slurry running during the use of the drilling fluid vibrating screen ? In the previous article, we have analyzed the reasons for the running slurry of the drilling fluid vibrating screen. In this article, we will talk about how to sol...

Why does the drilling fluid shale shaker run of slurry? There are several reasons for the drilling fluid shaker. Today, the editor of Xi'an HL will give you a brief introduction, hoping to help customers who encounter such problems. However, we must b...

Why does the mud desander not discharge sand? The mud desander is a device used to remove drill cuttings and sand in the mud in the mud purification system where the mud returns to the ground. Sometimes the mud desanding device will have a malfunction of...

Centrifugal sand pump is designed for pumping drilling fluid or industrial suspension (slurry), and can pump abrasive, viscous (sexual) and corrosive liquids. Compared with ordinary pumps, it has the characteristics of excellent performance, large flow, h...

What is the working process of the mud cleaner ? What is the working principle of the mud cleaner? Today, the editor of HL will give you a brief introduction of the drilling fluid cleaner. The drilling fluid mud cleaner plays a connecting role in the enti...

What are the daily maintenance of mud cleaners ? The drilling fluid mud cleaner needs to be used in combination with the desanding supply pump and the desludging supply pump in the working process. At the same time, the appropriate desanding cyclone and d...

What is the difference between a slurry pump and a mud pump? Generally, it is necessary to analyze and compare the slurry pump and the mud pump from three aspects. Today, the editor of HL Petroleum will give you an analysis from the following three aspect...

Drilling fluid sand pumps are relatively common in oilfield production. So what should we pay attention to when using sand pumps? Today, the editor of HL will give you a brief introduction of it. The impeller of the mud sand pump is fastened to the pump s...

There are generally several types of mud agitators , including direct-connected mud agitators, vertical mud agitators, helical gear type agitators, and drilling fluid agitators are important equipment for drilling fluid tank solids control systems, mainly...

Using the correct method to install the mud cleaner can better remove the harmful solids in the drilling fluid, improve the performance of the drilling fluid, and meet the requirements of the new high-pressure jet drilling process. Today's editor of H...